We service both gas and electric furnace systems with manufacturer-trained technicians.
Flat-rate pricing quoted after diagnosis, no pressure toward a premature system replacement.
If you're dealing with a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air, you already know furnace failures carry a safety dimension — carbon monoxide and gas leaks — that most other HVAC repairs don't, so the diagnostic has to start there.

Most furnace repair problems give some warning before they turn into a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air — catching it early usually means a shorter, cheaper fix.
Our technicians treat every furnace repair call in Van Nuys, CA the same way, whether it's a straightforward fix or a stubborn intermittent fault that two other companies already missed.
Every truck across Van Nuys, CA carries the tools and common parts specific to furnace repair, so most calls finish in a single visit.

Every furnace visit includes a combustion analysis and carbon monoxide test before any repair recommendation.
Our crews are trained on standing pilot, hot surface ignition, and electric resistance furnace systems alike.
Diagnosis happens first, and the quoted flat rate reflects the actual confirmed fault.
We understand a dead furnace in winter is a pipe-freezing risk, not just a comfort issue.
From the first symptom to the final fix, these are the specific furnace repair services our Van Nuys-area crews are equipped for.
Standing pilot systems get checked for thermocouple failure, the most common cause of a pilot that won't hold. This is one of the most requested furnace repair calls we get across Van Nuys, CA.
A gas valve that won't open or won't seal is tested with proper manometer readings, not just listened to. Techs handling gas valve diagnostics carry the specific parts and tools this job calls for, not a generic kit.
A cracked heat exchanger is a carbon monoxide risk and gets flagged immediately with the furnace shut down if needed. This is one of the most requested furnace repair calls we get across Van Nuys, CA.
We test motor amp draw against rated spec before replacement. This is one of the most requested furnace repair calls we get across Van Nuys, CA.
We inspect the full flue run, not just the connection at the furnace. This is one of the most requested furnace repair calls we get across Van Nuys, CA.
We test low-voltage circuits before condemning the board. Techs handling thermostat & control board diagnostics carry the specific parts and tools this job calls for, not a generic kit.

Tell us the symptom — no ignition, cold air, gas smell, or error code — and we route accordingly.
Techs arrive with combustion analyzers and common ignitor/gas valve stock loaded.
Flat-rate quote follows the confirmed fault, before repair begins.
Most ignition and control repairs finish same-visit.

Tech tested the ignitor's resistance right in front of me and swapped it in under thirty minutes.
Old furnace was blowing cold air even though the blower ran fine.
Shut the furnace down immediately for safety and walked me through the options.
Thermocouple was the culprit, replaced and tested before the tech left.

Usually a failing ignitor or a fouled flame sensor — both are testable with the right equipment rather than replaced blind.
We'll walk you through options including repair versus replacement honestly.
Could be a delayed ignition fault, a failed gas valve, or a limit switch issue — a full diagnostic narrows it down.
Yes — our technicians are trained and certified on both fuel types.
Immediately — leave the area and call, don't attempt to diagnose it yourself.
No-heat calls during freeze warnings are prioritized across Van Nuys, CA.

Our furnace repair crews are positioned throughout Van Nuys, CA to keep response times realistic, not just promised.
☎ Call +1-866-805-8548 for Van Nuys Service